Email Document Reference

Enter your email address below and the reference for this document will be sent to shortly from webmaster@ceesi.com.

Title: Gage Block Calibration With Computer Assist
Author: Lloyd A. Carver -
Source: 1983 Measurement Science Conference
Year Published: 1983
Abstract: In the past we have had the same problems with repeatability on gage blocks as have many others. Among the steps we took to eliminate this problem was the initiation of a semi-automatic calibration program. The heart of this was to be a micro-computer. To this end we wanted a unit that would (A) Store data from our Standard Blocks, (6) Store data on each set of blocks brought in for calibration, (C) Store the tolerance for each block brought in for calibration, (D) Store the in tolerance or out of tolerance condition found on each block, (E) Determine whether or not a set of blocks must be down-graded, (F) Print a Certification for each block set brought in for calibration, (G) Measure each block for length, (H) Calculate parallelism for each block, (I) Perform calculations to determine if the block set in for calibration is within tolerance, (J) Close the measurement loop on the standard block to insure the measurement was good and determine the uncertainty of the particular standard block, (K) Store measurement assurance data for determining random uncertainty at any give time

In order to prevent spam and automated file downloads for documents within the Measurement Library, please follow the instructions below and then you will be able to email a reference to this article.